Replacing Mits. 65" front Screen

[The Law]

I decided to remove the front screen on my mits to see if the glare would go away

After popping off the top portion of the screen, I noticed that it removes the entire screen - not just the glare inducing protective screen..... :(

...so now I want to put it back.

but I can't :bang:

There are 3 clips that it appears I need to lift the screen up and over in order to do this. I only need to lift maybe a centimeter or so, but am a few mm's shy :mad:

Anyone know how to put this back together? Will I need to pop the rest of the clips and go back in top-end first?

Anyone know where I can find a tear apart for this box?

I'm afraid of dust buildup now....I just can't leave things alone :)

Thanks in advance.

[StarvingForHDTV]

Why did manufacturers make glare screens anyway? It's just hard for me to imagine what they were thinking.

Too bad you can't get rid of yours.

Good luck finding a solution. Maybe put some of that blue painters tape over the top while you come up with the real solution.

[The Law]

Why did manufacturers make glare screens anyway?

They all have brothers in the curtain industry...

[Marc G]

I remember reading that on some RPTV's you can expect the screen to bow out in the middle to get the screen on or off. That little bow might give you the mm's you need.

[The Law]

I was able to get the screen back on with a little help from a screwdriver to bend the clips a couple mms. The screen is back on (thought not as tight as orginal - but tight enough to keep the dust out).